Tweco 7-3445 Bedienungsanleitung PDF herunterladen

Manual 0-2773 1 Installation Instructions 8/21/01

General Information

This Replacement Torch Adapter Kit is to be used to connect the Thermal Dynamics Plasma RPT Series Cutting Torch

to the following equipment:

• Thermal Dynamics Pak Master 50 with Smart Torch

Parts Supplied

The following parts are included in this kit:

• Signal Pin Connector with Wires and Connectors (1 ea)

• Pilot Adapter Fitting (1 ea)

• Rubber Insulator (1 ea)

• Tie-Wrap (1 ea)

Installation

Install the Adapter Kit per the following procedure:

A. Disassembling Old Quick Disconnect

To disassemble the quick disconnect connector, use the follow-

ing procedure (see Warning):

1. Disconnect the torch leads from the power supply.

2. Turn the outer retaining nut until one of the three set screws in the inner retaining ring is visible through one

of the slots in the nut.

3. Partially loosen each of the set screws which secure the inner retaining ring and boot onto the quick discon-

nect body. If the set screws are turned too far out, the outer retaining nut will not turn properly.

Rotate outer retaining

nut to access all

three set screws

Outer Retaining Nut

Set Screw

(Three)

A-00028

Loosen Set Screws

Manual 0-2773

RPT Adapter Kit

Catalog # 7-3445

Installation Instructions

NOTE

For Mechanized Systems refer to the

Torch Control Cable Wiring Dia-

gram on the last page of this Manual.

WARNING

Disconnect primary power to

the system before disassembling

the torch or torch leads.

1 2 3 4

Inhaltsverzeichnis

Seite 1 - Catalog # 7-3445

Manual 0-2773 1 Installation Instructions 8/21/01General InformationThis Replacement Torch Adapter Kit is to be used to connect the Thermal Dynamics P

Seite 2 - Removing Signal Pin Connector

Manual 0-2773 2 Installation Instructions 8/21/014. Pull the protective boot and inner retaining ring from the quick disconnect body.Protective BootOu

Seite 3 - Disconnecting Leads

Manual 0-2773 3 Installation Instructions 8/21/01Negative/PlasmaLead ConnectionPilot LeadConnectionA-00031Disconnecting Leads11. Remove the protective

Seite 4 - Quick Disconnect

Manual 0-2773 4 Installation Instructions 8/21/0111. Install the proper torch consumables for the Power Supply amperage.12. Connect the torch to the P

Kommentare zu diesen Handbüchern

Keine Kommentare

Tweco 7-3445 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Tweco 7-3445 herunter. Tweco 7-3445 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Tweco 7-3445